Re: Make it handle
If you have an idea, sooner or later you need to test it out to see if it works. Otherwise, it's just a guess of somekind. My Silver Bullit effie (don't hate on it) looses a bit of traction into and out of the corners, and thats something I've been working on. So, I had this idea. The panhard rod is a typical one. Urathane adjuster on one end, and a rod end on the other. Needless to say, it doesn't give much. I can fell the weight shift going into the corners and right as the wieght fully shifts over, the tires loose a bit of traction. So I started to think of ways to load the tire softly. I see these 'bisquit' torque rods that the dirt oval guys run, typically on the top link of a three link, to ease in the torque load on acceleration. Hmmm, could I use this on the panhard rod? Here is the Speedway torque rod next to my panhard rod.
__________________
GoodGuys 2012 Pro-Truck Champion
2012 Truckin' Throwdown Champion
GoodGuys 2011 National Champion
2011 Truckin' Throwdown Champion
GoodGuys 2010 National Champion
Proud to put our products up against all others!
Last edited by robnolimit; 08-05-2011 at 06:33 PM.
|