The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 TT · 09-23-2011, 12:36 PM

Decided to put a set of stock rubber clam shell mounts & matching rubber trans mount in the truck for now until I have some more things to order from Summit.

New grade-8 hardware as with the crossmember.

I need to test fit the engine, get everything squared up and install the trans crossmember then I can mark the lower motor mount bolt hole locations, drill them out & put the other two fasteners in for each mount bracket.

That will have to wait until I drop the drivetrain into the 67 C10 so there is enough weight on the front end that I can pull the C2500 LD 6-lug disc parts off of it, get them painted and installed onto the stepside.

09-23-2011, 12:36 PM	#42
68 TT Still plays with trucks Join Date: Jul 2009 Location: Spokane, WA Posts: 3,556	Re: 69 C10 swb stepside project 45 ACP Decided to put a set of stock rubber clam shell mounts & matching rubber trans mount in the truck for now until I have some more things to order from Summit. New grade-8 hardware as with the crossmember. I need to test fit the engine, get everything squared up and install the trans crossmember then I can mark the lower motor mount bolt hole locations, drill them out & put the other two fasteners in for each mount bracket. That will have to wait until I drop the drivetrain into the 67 C10 so there is enough weight on the front end that I can pull the C2500 LD 6-lug disc parts off of it, get them painted and installed onto the stepside. Attached Images __________________ miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars