[spousta]

i purchased another 55 chevy cab and cut it up to use for mocking the motor and everything up. heres some older pictures of the rolling frame before i put the rear subframe up higher in the frame, and the second set show how low it will sit with 0 air pressure in bags. the truck should ride 4-6 inches higher than the stance it has now.









i need to tub the rear bed which i was trying to avoid and i again i need a smaller wheel in the back with a better offset but heres some better pics of the ride





so now i can throw a motor in and create a transmission brace. also while i have everything there i can go ahead and start doing my stainless brake lines. and run everything i need. i think its a good dropped height.