Quote:
Originally Posted by 72KAY20
Running lights look great. Any advice on how to snake/run the wires? Was thinking about putting some running lights on the top of my cab. May not since I don't have the correct roof with the raised area around the lights.
|
That's a good question. The factory ran up the driver side windshield post. It may be tough to do with the roof skin on. Perhaps run a power lead around the inside windshield gasket and poke into the roof cavity beneath the gasket. Then drill the roof holes and fish the wire from there. Below I included some photos of how I ran the wires befor installing the original roof skin on the donor cab.
Another suggestion is to replace the roof skin since 98% of these trucks have rust issues up there but that's a lot more involved!
Posted via Mobile Device