[dean jendro]

Craig,

Here's what I have from my old clutch setup. The only thing I couldn't find was the return spring but that is the easy part. I have pictured the whole assembly but I will send you the clutch arm assembly only. You may have to pull the shaft out of your brake arm assembly and clean out the crud from both ends because those 2 plastic bushings pictured on the clutch shaft go in the ends of the brake shaft, then the clutch shaft goes thru the center of the brake shaft. Kinda hard to explain but it will all be clear when you get all the pieces together. If this is what you need I'll ship it to you this week. The complete clutch arm assembly is shown in the last picture. The retainer bracket slips on the knurled end of the shaft and is secured with a bolt and nut. There's a hole in the opposite end of that bracket that secures it to the clutch actuator rod. You can see most of that in McMurphy's photos.

Dean