Quote:
Originally Posted by rs72z
Nice truck. How did you lower the seats?
|
The driver's side is power so the mounting brackets where very tall so I just cut out desired amount and rewelded them. Only tricky part was I had one mounting point drop down because the floor as we all know is not flat. On the passenger side the seat has two sliding mechanisms one slides the whole seat up and out of the way for passenger entrance to the back and the other is the front back adjustment. I simply drilled the rivets out and took out the whole sliding mechanism for the passenger entrance to the back one and then cut the feet off the front back one and rewelded in there desired location..All in all it was very simply just a little time consuming and a lot of measurements..