The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Painter D · 06-10-2012, 10:56 PM

I put in some new lower cab corners while I was at it, then I adjusted the door and cab corner gap by slicing the the full length of the cab corner, moving it back about 1/16" and welded it back together. Then bodyworked it all and primed it all up.

06-10-2012, 10:56 PM	#2
Painter D Registered User Join Date: Jun 2007 Location: DFW (Forney) Posts: 1,529	Re: Locomotive Lugnut I put in some new lower cab corners while I was at it, then I adjusted the door and cab corner gap by slicing the the full length of the cab corner, moving it back about 1/16" and welded it back together. Then bodyworked it all and primed it all up. Attached Images __________________ '58 SWB Fleetside...Front & Rear Porterbuilt Dropmember, 6.0 LS /4L60E. Accuair E-level, 20 Billet Specialties (Vintecs) '63 Buick Riviera ... AccuAir E-level, 20" Billet Specialties (Vintecs) http://67-72chevytrucks.com/vboard/s...=528853&page=5 Last edited by Painter D; 06-10-2012 at 11:01 PM.