Progress has been a bit slow lately, got another job so progress may be slow for a while, but should pick back up once I go back to school in the fall. Only thing I managed to get done was cut out plates to box the frame in on both sides behind the motor mount cross member, and got 1 side cut to box the frame from the shackle mounts to just behind the rear cab mounts. Still have to cut some half circles along the edges of the plate so I don't turn the frame into a dirt trap. Only 1 pic for now. Hopefully I can get the other side done soon, get it painted, and set the cab down on the frame for good sometime in the next few weeks. Hopefully I can get my Dana 60 outer parts for my Eaton/60 soon too and get it under the truck.
Plates aren't finished yet, just checking fit up...