Thanks Mike. I’m going to document this process no matter how it turns out. I wish there was already a photo process posted somewhere that I could also follow!
This afternoon I spent almost 2 hours removing the residual urethane adhesive and gasket crud lines from the windshield eventually it came out spotless:
First pass at attempting to install the windshield gasket took about the same amount of time. I had it completely installed twice, but the stretch across the top was so tight, once an upper corner was completed the other side popped off. Taping in place didn’t help. The answer is I’ll have to pull more stretch out of the lower section of the seal before I can complete the task. It’s going to take two of us to pull some stretch in it so that will have to wait until tomorrow morning.
