BENCH SEAT (7 OF 8)
Finally the foam arrived and I went to work on the bottom once again. I cut out the first repair and glued in the two new blocks.
After the rough shaping was done, I set the foam on the frame and I found that helped a lot. Once I had the bolster channels cut in, the shaping moved along nicely. The templates made a big difference, guiding me in the right direction while shaping.
After the shaping was done, I glued in a section of burlap on the seat bottom where it meets the springs similar to the original construction.
Finally the bottom was ready and I installed the cover over it after letting it sit out in the sun to soften up.
Here is the pile of scrap left over from this project ( no, not the Vette under the cover, the stuff on the hood ! ).