Quote:
Originally Posted by aggie91
I noticed your have AN fittings in the water pump for the heater lines. What did you use to install those? How do the factory hose connections come out?
BTW, it is looking good!
|
Thank you. I had to use a little cutting, prying and pulling to get the fittings out, there just pressed in. The I use a 3/8 pipe tap for the smaller hole and a 1/2 pipe tap for the larger hole. I didn't have to do any drill to the holes. The 3/8 hole was a 3/8 npt to -10 AN fitting. The 1/2 hole was a 1/2 npt to -12 AN fitting.
I just took my time tapping the holes out didn't want to take a chance of cracking and breaking the aluminum. I was harder to get the old ones out then to put the new ones in. They don't want to come out very easy.
Thanks again for the words. Have a good day,
Robert