Here's what I've been working on, I made some sheetmetal mounts for my Vintage Air system. I really didn't like the ones that came with it. Next, I needed a bracket to mount my PCM up under the dash so I fabricated this one. It took me a few tries, and numerous hours, but I got one I'm happy with the outcome.
Vintage Air mounts, fabricated from 316 Stainless:
Shown mounted
PCM Bracket work, I made this piece first:
Here's where it's going to mount:
Made a cardboard templet:
Welded up the prototype:
Notice the weld is broken in this one:
Had to tweak it a little....
Final design:
Upper bracket machined from one piece
Started install:
Nut plate on the back side:
Finally Mounted:
Shown with connectors installed. It's still visible but not too bad. Once I route the wires on the modified harness I think it will work good.
This is what I started working on next:
