The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Pro Performance · 04-21-2014, 01:49 PM

The mock-up of the PB suspension. I can't say enough how nice these components fit together, and the quality. I am not just saying that because I sell it

, but it's truly a very nice USA made product.

I did make a template for the rack notch, since I found it easier to mark the location and cut on the outside of the frame rail. It was just a little easier to tape this to the frame and mark my cutline.

04-21-2014, 01:49 PM	#23
Pro Performance Registered User Join Date: Aug 2010 Location: AZ Posts: 3,069	Re: 63 C10 SWB Dropmember Build The mock-up of the PB suspension. I can't say enough how nice these components fit together, and the quality. I am not just saying that because I sell it , but it's truly a very nice USA made product. I did make a template for the rack notch, since I found it easier to mark the location and cut on the outside of the frame rail. It was just a little easier to tape this to the frame and mark my cutline.