Quote:
Originally Posted by swamp rat
Thanks for the door tips!
If i have to go up to the body line on the door, would you recommend cutting right on the sharp bend or just above or below it by a given amount?
|
I'd keep above or below the feature line minimum 3-4" if you can IMO. Stitch weld slow. I seldom use the entire patch panel. Trace, cut and trim panel to fit whats needed. I had to use the entire cab corner. Previous owner had a set brazed in. Warping was real bad. Not fun doin bodywork inside the features on the rear of the cab. I'm by no means a pro.