Re: 700R4 build thread.
Install the forward clutch piston (630) into the forward clutch housing (628). If reusing the Aluminum Forward Piston, Install Lip seals first. I do not use TransJel on the outer piston seal, Use ATF, Fit the Forward Piston into the Clutch Housing using you finger nail, Lube the Inner seal with Transjel.
**Note, Only use a 3-4 Apply Ring that has a 7 stamped on it, This is the shortest apply ring allowing the most room for 3-4 clutch stack-up**
Place the 3-4 Apply ring on the bench with "Fingers" up, Place the 3-4 clutch return spring assembly in the middle of the apply ring.
Place the Forward Piston & Housing on top of the return spring, Align the 5 tabs on the Forward piston with the Fingers on the apply ring.
|