[Russell Ashley]

Here's a pic of the trim clips that I have. I bought the trim and clips from a forum member so I don't know where he got them. I don't remember who it was and don't think he checks in here any more.

I drilled a hole in a flat sheet of steel to check the fit of my clips, and used a counter sink to ease the edge of the hole to make the clips go in easier. My test panel was flat and the truck area where the trim goes is dished, but even with the dish I'm pretty sure that my clips would not hold the trim tight against the cab. The clips did fit the moulding channel fine, but left too much room between the panel and the trim. I think I am going to explore other options on mounting this trim. Or maybe leave it off.