The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

chevy_mike · 02-26-2015, 05:18 PM

Yeah, I think '68 (maybe '67) and later use this style mount and idler arm. '66 and earlier uses a different idler arm/mount but I think if you drill the correct holes in the frame, you can use either style. Make sure your center link is level and parallel to the cross member.

FYI - I realized long after that picture was taken, I have the upper control arms swapped side for side. The hole with the bump stop should be to the rear, not the front. Doh!

02-26-2015, 05:18 PM	#116
chevy_mike Never Ending Projects Join Date: Jul 2006 Location: San Diego, CA Posts: 3,836	Re: Project Christine V2.0 Yeah, I think '68 (maybe '67) and later use this style mount and idler arm. '66 and earlier uses a different idler arm/mount but I think if you drill the correct holes in the frame, you can use either style. Make sure your center link is level and parallel to the cross member. FYI - I realized long after that picture was taken, I have the upper control arms swapped side for side. The hole with the bump stop should be to the rear, not the front. Doh! __________________ . 1965 C10 Panel, Tiki Express http://www.67-72chevytrucks.com/vboa...d.php?t=506580 SOLD 1968 Chevy C10, Long, Fleetside, Hot Rod Hauler http://67-72chevytrucks.com/vboard/s...d.php?t=313233 SOLD 1965 Chevy C10, Long, Fleetside, Hot Rod C10 http://67-72chevytrucks.com/vboard/s...d.php?t=415702 SOLD We were given two ears and one mouth for a reason... listen twice as much and speak half as often...