[Mjminino]

Well, I got it all situated. I just ended up relocating the factory mount and removing the rear ends mount. What a B%$ch it was to remove the rivets!!!! Look how far I had to move it though! What I did was went and measured how far the differential cover stuck out on my other 64 and clamped and re-clamped etc the newly relocated bracket. Factory is roughly 2.5 inches from the flange (not the cover itself). I added half an inch just to be on the safe side. I don't think I will have a problem because I am not going with anything fancy for a cover. BUT guess what!?!?!?!?! Christine's @$$ now has a trac bar!!!

Now that her a$$ has the trac bar I can finish putting the shim and shock relocation bracket on the drivers trailing arm and then that will be all squared away outside of the new axles, posi, 3.73 gears and Captain's impala disk brake set up.