Well.....I cleaned up a bit, dropped the frame down on the IRS and set the frame to where I might want it at ride height. Front running board brackets are at 5 3/4" off the ground.
Looks like I should have made my C notches a bit bigger. The toe bars are pretty close to the frame. Either get a toe bar re-locator kit to lower the bars to the bottom or raise my ride height. I won't decide on that till I get the cab on the frame with a bed side and fender and front fender.
Things look tight that I may not be able to run a sway bar. I've read that some say it's not needed. I'd like to have the option to install it if needed.
Anyway's, here is some pictures of tonight's progress. So far, things look like the truck is going to be low! I like it! We will see once I mock up the sheet metal.
