[Alberta65]

Alright so two steps forward and a few back but oh well. I have put an order in for lmc parts for a pillars and inner rockers so i figured I would begin by getting some practice on my fender patches. Starting with this one in the rear:



The whole underside of the lip was rusted so I decided to just replace the whole thing... unfortunately the lmc patches I ordered had a shorter curve than the factory wheel arches so it took a whole bunch of hammering and a couple patch repairs I think I got it to follow the lines. PS don't make too much fun of my welds this is my first ever body work job so I am trying to figure things out as I go. Lesson number 1 I have learned is penetration is numero uno!!








Next i was able to recruit my brother to get the hood off and up on the rafters and start pulling apart the front clip. Cannot wait to re-wire this thing the more I pull it apart the more scare I am of the hack job the PO did.

so this was how it looks when the lights went down today: