Lks Dcvn - 1972 2WD Blazer Build
It's time to start a build thread for my new project - a 1972 2wd factory Blazer.
It's been in my garage since Memorial Day and have been working on it (not as much as I would like) over the past few weeks.
Specs:
1972 Factory 2wd Blazer - CC VIN
Original Color - 524 - Red/Orange - exterior was painted black at some point
Black Seats - both covers in poor shape
Black Rubber Floor - ripped and gone in most spots
No Rear Seat Option - seems rare to me
Stock AM/FM Radio option on SPID - long gone
No Motor/Trans - was a 307/SM 465 truck
Lots of rust in the doors, bed and floors
Hood was beat up a bit and fenders needed some work
Tailgate was sticking and had rust on outside and inside
Doors were in bad shape as well - Driver side was rusted at the hinges and Passenger side wouldn't open when I got it
Black Single Wall top/hatch was in great shape - just needs minor tweaking and cleaned up. Hatch lift sticks on one side.
Chassis was clean with only surface rust and no surprises
More mud dauber wasp nests than I had ever seen on one vehicle
These were the pictures used to decide if I was a buyer or not...
|