Quote:
Originally Posted by Rod Run
For the exhaust I went with 2 1/2" pipe, so what I did was use a 3" hole saw to cut the hole through the cross member and then used some 3" pipe and used it as a sleeve to finish it off. It is totally ok if the saw cuts a little oversize, because you will be filling that when you weld the sleeve in anyway.
The minor problem that you will run into, is that there is no "meat" to drill into in that area of the cross member. What I did, was just tack welded a small piece of scrap metal in in position that I wanted to use as the center. I hope I didn't over confuse that for you?
The wheels are Cragar Soft 8
17x8 front & 17x9 rea, with 4.5 " & 5" backspacing. I am also using CPP's modular spindles, so that's moving my spindle in a little more than a stock application
|
ROD..Great great info..thank you so much!!