My next step was to run 3/8 stainless fuel lines from the to the rear of the chassis where the custom fuel tank made by Boyd Welding. This was my first time working with stainless hardline and it was definitely a learning experience.
First off I drew the chassis profile on my work table so I didn't have to keep going back and forth from the chassis to the table. Here you can see where it will go along side the frame rail and up and over the rear "c notch".
And installed on the chassis
Next was to mount and tie in the aeromotive fuel filter.
Here is where the front lines start. They will have flexlines made to go to the fuel rails.
The ECU and Custom harness built from scratch showed up from Modern Vintage Systems as well. That will be the next step!
