Quote:
Originally Posted by LT7A
Good build. I like the, learn as you go, method. I look forward to doing that with welding at some point too. I also grabbed some hammers and dollies to start tapping out little dents. Completely understand your comment about reverse dents. Did you get some good summer use of of this rig?
|
Thanks, and I sure did. I drive this truck a lot, and I'm guilty of driving it around partially disassembled. Right now the dash pad and gauge bezel is off but I've driven it all summer like that. I figure it'll be ugly and obnoxious until I'm done, and then it still will be to most people anyway. So drive it, right? Here's a pic. I have worked a little at repairing the original dash pad and installing a switch panel into the gauge bezel, they will be ready to install soon, I'll have new updates then.