Re: Rat repair.
ON the driver side when I installed the outer rocker I just pulled the bottom in and spot welded it in place doing so pulled the rocker surface inward and I had to fill with bondo.
Looking at this side I think a better solution will be to do some "adjustment" to the flange at the rear, a little stretch about 1" from the door line, then a pie cut and re weld down lower to get the outer rocker contour closer to the stock cab corner.
1st pic not pulled in, 2nd pic pulled in, 3rd pic not pulled in.
If you had to do an adjustment in this area this can you enlighten me on what you did?
In the hustle for the holiday, may not be getting a whole lot done for the next week.
Happy Thanksgiving!
.
Last edited by swamp rat; 11-21-2016 at 06:56 PM.
|