Quote:
Originally Posted by 68blackbird
Ok, saw the pics in the link you sent, very good info!! Thx!!
|
Cut the bulk away to get at it from inside the cab. then trim it bac to where you can use a get the spot weld cutter at a 90 degree angle without interference. Take your time on the spot welds making sure you only cut through the top layer. patching hole in the lip is a big PIA.
A Steck seam buster tool is a big help on this job.. tool number 20015. you cut about 90 % of the way through and then use the tool to strip off the remaining metal
http://www.steckmfg.com/20015_SeamBuster.html