Quote:
Originally Posted by First c10
Hey Mike I used the brush on also. I could do a better job of getting it in the gaps and less clumpy.
I seen a video of a shop using brass filler rod and a tig welder. I think in the future I may try that.
|
Quote:
Originally Posted by swamp rat
Mainly for ease of application, Seal any seam on both sides, any weld on both sides or any panel join. Per the rockers I don't know if its correct or not but I will put a little on both ends to fill in any small gaps and where the bottom is welded to the inner rocker on the back side, I do also intend to brush the seam sealer along the top where the inner and outer join just below the weather strip lip.
|
That's good information from both of you to store away for later. Don't know when I will need to worry about seam sealer, but now I know what to get and the best way to apply it. Thanks!