The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Jason7121 · 02-27-2017, 02:14 PM

I used stick on clips where there was no access to put a nut on back side. Holes I did drill I drilled 1 size larger than the threaded stud so moldings could be moved around a bit until aligned. The spots where there is a screw going through to hold them I drilled 1 size smaller than the screw for a tight fit of screws. Hope this helps.

02-27-2017, 02:14 PM	#14
Jason7121 Registered User Join Date: Jun 2016 Location: Visalia California Posts: 891	Re: 71 C10 6.0 LS ground up build I used stick on clips where there was no access to put a nut on back side. Holes I did drill I drilled 1 size larger than the threaded stud so moldings could be moved around a bit until aligned. The spots where there is a screw going through to hold them I drilled 1 size smaller than the screw for a tight fit of screws. Hope this helps.