The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - I need a measurement off your stepside truck

drmatera · 03-22-2017, 03:20 PM

I'm trying to figure out how much wheel I can put on the back of my '65 Step side GMC but I don't have a bed to make measurements. Specifically I'm looking for someone to measure from the outside of the frame rail to the inside lip of the rear fender. I'm running an Explorer 8.8 so I can't use the stock axle back spacing

03-22-2017, 03:20 PM	#1
drmatera Registered User Join Date: Aug 2016 Location: Nicholson, Ga Posts: 134	I need a measurement off your stepside truck I'm trying to figure out how much wheel I can put on the back of my '65 Step side GMC but I don't have a bed to make measurements. Specifically I'm looking for someone to measure from the outside of the frame rail to the inside lip of the rear fender. I'm running an Explorer 8.8 so I can't use the stock axle back spacing __________________ 1981 K10 (4.8 / 4L60E swap) 1982 C10 (5.3 / 4L80E swap) 1985 C20 Suburban (454 / 4L80E)