[Captainfab]

You will need a 168 tooth flywheel for a '86-'02 350. Your clutch should bolt up. Then you will need either a set of '63-'66 small block or '67-'72 230/250 engine mount brackets. You can also use the engine mounts and corresponding brackets from a '73-'86 C20/30 or a '87-'91 R20/30. But with those you may need to drill a couple holes and may need a 1/4" spacer on top of the frame. You will also have to trim the top flange of the frame to use those. As for the clutch bellcrank, all you will need is the ballstud that screws into the block, providing the block you have is drilled and tapped in the forward location.