[N2TRUX]

I didnt realize when i started this overflow/washer bottle project I was creating a giant jigsaw puzzle. As hard as I try to measure and mark accurately, there were some variances in my drilled holes. What I discovered on reassembly is there are 9 wrong ways to put it back together, but only one right way.

I took everything apart to sand and paint before final assembly. When I put it back together the holes drilled in the panel didnt line up. I adjusted them to fit, and the exit hole for the washer line was off. Hmmm??? So I flipped it over and everything lines up just fine. Thank you Jesus. I was getting tired of playing that game.

I remounted the assembly once more and bolted it down. Now i need the washer pump to show up so I can get the project done.