Quote:
Originally Posted by gigamanx
Thanks. I was concerned with burning through but I had a test piece of exhaust I was using to set the welder. Definitely getting penetration through the tube. Any higher, it melts the edges of the tube when trying to weld the two together. Hopefully I got it right. I did do a bunch of about 1 inch long welds to tack it together and keep heat down. Started out with just spot welds but that was taking a LONG time haha.
|
ok, sounds good. it will have a good sound with that large diameter pipe all the way back. my 4.3 trucks always have the bendy straw y pipe.
and in the end the only one that would give you trouble is that butt joint where the two pipes join, the rest are slip joints so even tacks would keep them together.