The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**'68OrangeSunshine** · 10-30-2017, 04:43 PM

GMC1500 4x4, I have had a machinist build up a bushing-reinforced clutch lever. I don't remember if I used it on either truck, or if its still kicking around. But it was a thing of beauty.
Grumpy, those plastic spirals go inside the lateral pivot bar inside the cab. Both the brake and clutch pedals swing on it. Re-installing them cures that ''swingset squeek'' you get on a 40+ y.o. truck. I can't figure out how to get at it however.

10-30-2017, 04:43 PM	#5
'68OrangeSunshine Senior Member Join Date: Feb 2002 Location: Tucson, AZ USA Posts: 7,098	Re: clutch rod lever bushing? GMC1500 4x4, I have had a machinist build up a bushing-reinforced clutch lever. I don't remember if I used it on either truck, or if its still kicking around. But it was a thing of beauty. Grumpy, those plastic spirals go inside the lateral pivot bar inside the cab. Both the brake and clutch pedals swing on it. Re-installing them cures that ''swingset squeek'' you get on a 40+ y.o. truck. I can't figure out how to get at it however. __________________ Every 25 years I like to rebuild that 292, whether it needs it or not.