[Zeroman]

That is the engine wiring for the distributor and electric choke.

I, unfortunately, did not fill in those holes above the fire wall pinch weld and felt there was no good way to plug them without a repaint.

So, I went a head and ran the harness on top. I would have preferred to run it low and out of sight, but things happen.

I have not run my washer hoses as you can see the two open holes above the pinch weld. I am going to run a later model washer bottle with internal pump located in the original location, therefore, I was able to fill in the original hole with the three hole grommet.