Quote:
Originally Posted by Ben_Yeaton
VERY cool to see, thanks for responding. So you threaded the tapered insert into the spindle arm and then installed from the bottom side? Sounds very easy, once the inserts are machined that is. I would think a press in sleeve would work as well if it had a shoulder on it? Thanks again!
|
I think a knurl or pressfit might work but I was happier with a thread and red loctite. Installation was simple one the hole was drilled and tapped. I also didn’t want to weld to the cast iron. My friend even did it without a tapered reamer, but you could replicate this at home with a drill press and the right reamer which are available for our tapers
Posted via Mobile Device