The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - What did you do to your truck today part IV

Ken Cook · 01-11-2018, 08:46 PM

I fixed my hard to push door handle button by spraying the latch with PB Blaster. It's been pretty cold latly and I think the grease just lost its greasyness.

Replaced the door check/stop. Replaced the vent window rubbers and beltline felts.

Checked out why my heater fan would only blow on high. I was not sure if I need the switch or the resistor. So I pulled the plug from the switch and found the hot wire with a test light. Then I used a jumper wire to test the fan. It worked on all speeds so I thought I would be ordering the switch but after I plugged it back in all of the speeds are working. I guess the blades on the switch were dirty.

I also took the headlight apart to see why it's loose. It will need new adjuster screws.

I'd say it was a pretty good day.

01-11-2018, 08:46 PM	#17
Ken Cook Registered User Join Date: Apr 2017 Location: Ragley, La. Posts: 137	Re: What did you do to your truck today part IV I fixed my hard to push door handle button by spraying the latch with PB Blaster. It's been pretty cold latly and I think the grease just lost its greasyness. Replaced the door check/stop. Replaced the vent window rubbers and beltline felts. Checked out why my heater fan would only blow on high. I was not sure if I need the switch or the resistor. So I pulled the plug from the switch and found the hot wire with a test light. Then I used a jumper wire to test the fan. It worked on all speeds so I thought I would be ordering the switch but after I plugged it back in all of the speeds are working. I guess the blades on the switch were dirty. I also took the headlight apart to see why it's loose. It will need new adjuster screws. I'd say it was a pretty good day.