The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**jocko** · 02-13-2018, 09:11 PM

I hope nobody from LMC is reading this, but I use their catalog to find out what I need and then order where the quality is better. But they shouldn't get too upset with me, I order plenty from them when I have to... Anyway, note that the factory approach was a combination of metal and plastic. If you use the plastic clips, it is absolutely worth peeling the existing sticky backing off and replacing it with 3M two sided trim tape (a tip I got from leddzepp and it worked well). It sounds like a pain in the butt, and it is a little bit, but not too bad.

02-13-2018, 09:11 PM	#4
jocko Senior Member Join Date: Oct 2009 Location: Godley, TX Posts: 17,938	Re: Moulding Purchase Discussion I hope nobody from LMC is reading this, but I use their catalog to find out what I need and then order where the quality is better. But they shouldn't get too upset with me, I order plenty from them when I have to... Anyway, note that the factory approach was a combination of metal and plastic. If you use the plastic clips, it is absolutely worth peeling the existing sticky backing off and replacing it with 3M two sided trim tape (a tip I got from leddzepp and it worked well). It sounds like a pain in the butt, and it is a little bit, but not too bad.