The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*YoungPup1977* · 04-26-2018, 07:14 PM

You can do this without pulling the Valve body off the case, you mentioned band anchor above which is under the VB...
To make it a bit easier to get the 2/4 band out and back in...remove the 2/4 servo from the side of the case.

Dont forget to pull out the TCC solenoid before pulling the pump out, if it has the Input speed sensor on the stator make sure you disconnect the connector too.

What year is this 4L65E ?

Good Luck !

04-26-2018, 07:14 PM	#3
YoungPup1977 Account Suspended Join Date: Jun 2015 Location: No longer here Posts: 1,000	Re: 4WD to 2WD 4l65e from Hummer You can do this without pulling the Valve body off the case, you mentioned band anchor above which is under the VB... To make it a bit easier to get the 2/4 band out and back in...remove the 2/4 servo from the side of the case. Dont forget to pull out the TCC solenoid before pulling the pump out, if it has the Input speed sensor on the stator make sure you disconnect the connector too. What year is this 4L65E ? Good Luck ! Last edited by YoungPup1977; 04-27-2018 at 08:17 AM.