The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Mike C · 05-31-2018, 08:36 PM

Driveshaft interference suggests someone put a set of two wheel drive headers on the truck.

IF I was going to run headers again, they would be Heddmans again. Back in the late 80's they were the only ones that would clear the clutch linkage I could find. Got tired of returning crappy ones to Super Shops.

But I went to the 'vette 2 1/2" outlet manifolds on my Jimmy and we are doing the same on my kids Jimmy project. They work great, look great, are low to no maintenance and are cost effective at $120 from Speedway motors. Available other places as well.

05-31-2018, 08:36 PM	#14
Mike C Registered User Join Date: Dec 1999 Location: Austin, TX, USA Posts: 7,714	Re: Headers recommendation Driveshaft interference suggests someone put a set of two wheel drive headers on the truck. IF I was going to run headers again, they would be Heddmans again. Back in the late 80's they were the only ones that would clear the clutch linkage I could find. Got tired of returning crappy ones to Super Shops. But I went to the 'vette 2 1/2" outlet manifolds on my Jimmy and we are doing the same on my kids Jimmy project. They work great, look great, are low to no maintenance and are cost effective at $120 from Speedway motors. Available other places as well. __________________ 44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax