[Dan in Pasadena]

Thanks for the link Black Sheep. It says 1/2” stud but I easily put 7/16” washers on my studs last night so I THINK those are too large a diameter(?)

Thanks you guys for the comments. I ended up having to remove the bed side so I could take off the rear most cross sill yet again (miraculously I didn’t chip or scratch it!) and slid out one of the bed boards to tighten the fuel lines. Started truck hours apart to verify no leaks and the. Set about putting it all back together. Did it by myself. Dozens & dozens of trips up too and below in the creeper. Hate to admit it gave me quite a workout.

Glen, That tire pic was before I installed the washers. There was barely 1/16” clearance so that was definitely not gonna work. Not sure I like the Smoothies after all. I’m considering replacing with gray spoke Torq Thrusts or 17” Rally repops (w/redline tires).