[dsraven]

ok.
personally I would put the suspension at full jounce, like as far up into the frame as it will ever go, then mock up the cable routing. probably have a receiver bracket on the frame that the cable will plug into but don't plug it in now because they don't unplug easily. then lower the suspension to as far out of the frame as it will ever go and see how how the cable looks through the entire suspension travel. try to keep it clear of the 4 link parts if possible. the other plan could be to follow the 4 link bar up to it's pivot point and attach the cable receiver near there. thats if your cable is long enough. that way the cable and the 4 link will follow the same arc so no interference problems or cable length problems. you could clip it to the 4 link bar part way up even. that would put the cable on the outside of the frame unless you figure out a better way to attach the cable at the frame end so it ends up inside the frame. you could also get a longer cable made up to do the job if you decided to go that route.