[mvitale27]

Originally Posted by dsraven

there is an inner part,seen from inside with the door open https://www.classicindustries.com/pr...ts/t70968.html

there is an outer part, seen from outside with the fender off, the hinge bolt goes through it
https://www.classicindustries.com/pr...ts/cx1822.html

there is a filler part underneath that connects the two parts https://www.classicindustries.com/pr...ts/t70994.html

there is a front fender mount lower bracket that also attaches to the outer lower part https://www.classicindustries.com/pr...ts/t70921.html

gonna need some weld through primer as well

hope you got everything you need before the welder dude shows up.

I have the last 3 pieces for each side. I just need the first piece for each side, or the "face". I also have both front floor pan halves and both front cab mount supports. Also need the 2 roof panels mentioned above and rear cab corners.

In the meantime I have dissassmbled the bed. I have about 3/4 workable sides front panel and tailgate. All crossmembers good. Angle iron, wood, and sheetmetal welded on all sides was a nightmare. Ill post pics tomorrow.