The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jaros44sr · 11-02-2018, 05:18 PM

This is where it can be confusing, as the connectors look the same, but, there is a notch on the left one at the top and will not let them connect

I use my hemastats to keep the locking tabs from reengaging as you pry off on side

[url=https://flic.kr/p/2cAMx5k]20181102_113902

[url=https://flic.kr/p/2bd3ceZ]20181102_120842

you can see better the notch I am referring to in this pic

These are the cam and crank senser connectors

Started to install some of the wire care wrap, but didn't use tape to finish yet. I guess AJ was right, doesn't look as cheap

11-02-2018, 05:18 PM	#2974
jaros44sr Registered User Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,442	Re: PO has me PO'd This is where it can be confusing, as the connectors look the same, but, there is a notch on the left one at the top and will not let them connect I use my hemastats to keep the locking tabs from reengaging as you pry off on side [url=https://flic.kr/p/2cAMx5k]20181102_113902 [url=https://flic.kr/p/2bd3ceZ]20181102_120842 you can see better the notch I am referring to in this pic These are the cam and crank senser connectors Started to install some of the wire care wrap, but didn't use tape to finish yet. I guess AJ was right, doesn't look as cheap __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 11-03-2018 at 08:49 AM.