[sinannasirli]

Okay.. Now the choke is installed and here comes my comments and pictures..

1) The installation is very carburetor specific.. It is basically a long wire with sleeve (like proper choke cable, (but I could not use the sleeve, but used the sleeve that was on the truck, because the hole on my dash was a larger diameter). It is longer than needed so no problem there..

2) You supposed to drill a hole into the choke shaft and attach a double-L type bracket using the washers and screw provided where you hook the cable to... As my carburtor already had a choke, I only took the part that is attached to shaft and attached the bracket using the screw that is already on the carburetor...

3) The biggest challenge is to use a god position to attach the big L type bracket that is provided.... After spending hours and different setups, where the best was the carburetor attachment bolt on the intake manifold, I still was not happy and I decided to make my own bracket and using it..

I still attached a picture of the setup that supposed to work ( which I was not happy)