Sometimes things really do pee me off.
So I ordered a 1/2 inch spacer to get the air cleaner raised and fitted to the Holley carb in the Blazer.
Ermmmm, Nope.
Too tight, just no way of fitting it.
Call in the side cutters, and duct tape.
After correcting it, the gap was about 2mm and I placed it where there was a metal wall.
Done.
I will apologise in advance, but yesterday Harley was on one of her missions, holding tools, inspecting, approving and generally being an absolute pain in the butt. Certainly had the wind up her tail.
Kept on walking about the engine bay, despite me putting her on the ground repeatedly.
It was cold, and the wet and chill combined made me realise she is just mad for being out there.
Typically she to try out the perch.
Settling on the edge while I fitted the PCV valve to the truck as well.
So needed the latest bit of action on the Blazer.