If any of you missed it on page 11, I'm more or less following what "dayj1"
http://67-72chevytrucks.com/vboard/s...d.php?t=668385 in his 4.8L build thread. Yesterday, I worked first on the you Dirty Dingo LS trans x-member. I didn't like the how the engine was sitting in the frame so I did some modifying of the x-member. I also drilled a hole for the MAP sensor in the throttle body. I think I have all my sensors now worked out. next is adapting the wiring harness to fit the new configuration. Thanks Mike
Pictures:
1. Original location of trans x-member plate.
2. Trans x-member ready for welding.
3. Test fitting the trans...good to go.
4. Drilled hole for MAP sensor.
5. MAP installed.