[Orange Crate]

Not a whole lot of progress but some. I fabbed up a couple of links from 3/8" rod to try to get an idea of where my shift levers will end up relative to my bench seat when they are in 2 H, 4 H & L for each axle (front wheel drive only, rear wheel drive ect). The picture shows both axles in 4 H, so I think I want the links a little shorter to place the levers farther forward. I'll measure the links when I feel they are in the right place and then build the final linkage out of proper 3/8" rod ends. It's not completely visible but I have two original shifter levers together for my twin stink set up. You have to look closely but they are there. Alrighty then.....