The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Sooner71 · 03-24-2019, 08:33 AM

Yes, I'm looking to go cable.
After talking to the tech department at cpp ( classic performance products ), I found out that there wasn't no information on a 63 GMC throttle pedal conversion, so I had to figure out something, so I removed the original throttle assembly that was bolted to the side of the transmission tunnel. I found a flat spot next to that area and mocked up my lokar pedal and marked a line around the base of the mounting surface, then I put the plate that mounts to the firewall over the line that I marked around the base of the pedal to marke the 2 holes that needed to be drilled for the installation. Worked out perfectly.
Thanks for all y'alls responses.

03-24-2019, 08:33 AM	#5
Sooner71 Registered User Join Date: Feb 2017 Location: San antonio tx Posts: 5	Re: 63 GMC throttle pedal conversion Yes, I'm looking to go cable. After talking to the tech department at cpp ( classic performance products ), I found out that there wasn't no information on a 63 GMC throttle pedal conversion, so I had to figure out something, so I removed the original throttle assembly that was bolted to the side of the transmission tunnel. I found a flat spot next to that area and mocked up my lokar pedal and marked a line around the base of the mounting surface, then I put the plate that mounts to the firewall over the line that I marked around the base of the pedal to marke the 2 holes that needed to be drilled for the installation. Worked out perfectly. Thanks for all y'alls responses.