got the cab pulled, and did the cab corners after trimming the rear cab reinforcement. the cab will sit 3/4" lower in the rear and be level with the frame now.
I like to trim the big patch oversize so I can clamp it to the cab, then cut both the patch and the cab. makes welding it up nice.
went ahead and trimmed the pass side too low. HUBRIS!
inner needed some work
I guess I forgot a finished drivers patch picture, here is an in-process.
fixed my screwup on the pass side.
I would have had it all done but it darkened up and they are calling for rain today and tomorrow. if it rains tomorrow I will do frame stuff inside, if it is sunny I will tip the cab back and do the kicks/floor patches and the HVAC firewall chunk.