The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

DJ_Baar · 04-20-2019, 03:32 AM

I believe that was LMC for the replacement end spring. It was a little smaller, not as wide as I recall, but length to fit worked. Then replaced/repaired foam as needed to fit seat. And was able to clean and re-use most of the seat clips to frame and new hog rings to springs. Get a good set of hog ring pliers helps too - eBay.

04-20-2019, 03:32 AM	#108
DJ_Baar Registered User Join Date: Jul 2016 Location: New Orleans Posts: 362	Re: My '67 Chevy C20 "Camper Special" Build I believe that was LMC for the replacement end spring. It was a little smaller, not as wide as I recall, but length to fit worked. Then replaced/repaired foam as needed to fit seat. And was able to clean and re-use most of the seat clips to frame and new hog rings to springs. Get a good set of hog ring pliers helps too - eBay.